Virtual Private Networking Using IPSec Connections
313
ProSecure Unified Threat Management (UTM) Appliance
Figure 190.
3. Select the Enable NetBIOS check box.
4. Click Apply to save your settings.
Configure the PPTP Server
As an alternate solution to IPSec VPN and L2TP tunnels, you can configure a Point-to-Point
Tunnel Protocol (PPTP) server on the UTM to allow users to access PPTP clients over PPTP
tunnels. A maximum of five simultaneous PPTP user sessions are supported. (The very first
IP address of the PPTP address pool is used for distribution to the UTM.)
A PPTP user typically initiates a tunnel request; the PPTP server accommodates the tunnel
request and assigns an IP address to the user. After a PPTP tunnel is established, the user
can connect to a PPTP client that is located behind the UTM.
You need to enable the PPTP server on the UTM, specify a PPTP server address pool, and
create PPTP user accounts. For information about how to create PPTP user accounts, see
Configure User Accounts on page 378.
To Next Page
Loading...
Need help?
General