Virtual Private Networking Using IPSec Connections
314
ProSecure Unified Threat Management (UTM) Appliance
To enable the PPTP server and configure the PPTP server pool, authentication, and
encryption:
1. Select VPN > PPTP Server. The PPTP Server screen displays:
Figure 191.
2. Enter the settings as explained in the following table:
Table 79. PPTP Server screen settings
Setting Description
PPTP Server
Enable PPTP Server To enable the PPTP server, select the Enable check box. Complete the
following fields:
Start IP Address Type the first IP address of the address pool.
End IP Address Type the last IP address of the address pool. A maximum of
six contiguous addresses can be part of the pool. (The first
address of the pool cannot be assigned to a user.)
User time out Enter the time-out period in seconds, from 300 to 1800
seconds. If there is no traffic from a user, the connection is
disconnected after the specified period.
To Next Page
Loading...
