LAN Configuration
117
ProSecure Unified Threat Management (UTM) Appliance
Configure Routing Information Protocol
Routing Information Protocol (RIP), RFC 2453, is an Interior Gateway Protocol (IGP) that is
commonly used in internal networks (LANs). RIP enables a router to exchange its routing
information automatically with other routers, to dynamically adjust its routing tables, and to
adapt to changes in the network. RIP is disabled by default.
 To enable and configure RIP:
1. Select Network Config > Routing.
2. Click the RIP Configuration option arrow to the right of the Routing submenu tab. The RIP
Configuration screen displays:
Figure 63.
To Next Page
Loading...
Need help?
General