65
3
3. Manually Configuring Internet and
WAN Settings
This chapter contains the following sections:
• Internet and WAN Configuration Tasks
• Automatically Detecting and Connecting the Internet Connections
• Manually Configure the Internet Connection
• Configure the WAN Mode
• Configure Secondary WAN Addresses
• Configure Dynamic DNS
• Configure Advanced WAN Options
Note: The initial Internet configuration of the UTM is described in
Chapter 2, Using the Setup Wizard to Provision the UTM in Your
Network. If you used the Setup Wizard to configure your Internet
settings, you need this chapter only to configure WAN features such
as multiple WAN connections (not applicable to the single WAN port
models) and dynamic DNS, and to configure secondary WAN
addresses and advanced WAN options.
Note: The Wireless Settings configuration menu is shown on the UTM9S
only, accessible under the Network Config main navigation menu.
Internet and WAN Configuration Tasks
Note: For information about configuring the DSL interface of the UTM9S,
see Appendix A, xDSL Module for the UTM9S. The information in
this chapter does also apply to the WAN interfaces of the UTM9S.
To Next Page
Loading...
Need help?
General