Manually Configuring Internet and WAN Settings
91
ProSecure Unified Threat Management (UTM) Appliance
5. Click Apply to save your changes.
Depending on the changes that you made, when you click Apply,
the UTM restarts, or services such as HTTP and SMTP might
restart.
If you want to configure the advanced settings for an additional WAN interface, select another
WAN interface and repeat these steps.
Additional WAN-Related Configuration Tasks
• If you want the ability to manage the UTM remotely, enable remote management (see
Configure Remote Management Access on page 415). If you enable remote
management, NETGEAR strongly recommend that you change your password (see
Change Passwords and Administrator and Guest Settings on page 413).
• You can set up the traffic meter for each WAN, if you wish. See Enable the WAN Traffic
Meter on page 434.
Upload/Download Settings
These settings rate-limit the traffic that is being forwarded by the UTM.
WAN Connection Type From the drop-down list, select the type of connection that the UTM uses to
connect to the Internet: DSL, ADLS, Cable Modem, T1, T3, or Other.
WAN Connection Speed
Upload
From the drop-down list, select the maximum upload speed that is provided by
your ISP. You can select from 56 Kbps to 1 Gbps, or you can select Custom
and enter the speed in Kbps in the field below the drop-down list.
WAN Connection Speed
Download
From the drop-down list, select the maximum download speed that is provided
by your ISP. You can select from 56 Kbps to 1 Gbps, or you can select Custom
and enter the speed in Kbps in the field below the drop-down list.
Table 20. Advanced WAN settings (continued)
Setting Description
To Next Page
Loading...
Need help?
General