EasyManuals Logo

NETGEAR UTM5 User Manual

NETGEAR UTM5
645 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #564 background imageLoading...
Page #564 background image
Wireless Module for the UTM9S
564
ProSecure Unified Threat Management (UTM) Appliance
2. Select the Enable WDS check box.
3. In the WPA Password field, enter a password between 8 and 63 characters.
4. Click Apply to save your settings.
5. Enter a MAC address of a peer in the MAC Address field.
6. Click Apply to add the MAC address to the WDS Peers table.
7. Repeat step 5 and step 6 for any other MAC addresses that you want to add to the MAC
Address table.
 To configure WDS on a peer:
1. Configure the same wireless security that you have configured on the UTM9S.
2. Enter the MAC address of the UTM9S’s access point, which is displayed on the WDS
Configuration screen of the UTM9S.
3. Enter the same WPA password or WEP key that you have entered on the WDS
Configuration screen of the UTM9S.
Note: Make sure that you use the same wireless security configuration on
all WDS peers.
 To remove one or more MAC addresses from the WDS Peers table:
1. In the WDS Peers table, select the check box to the left of each MAC address that you
want to delete, or click the Select All table button to select all MAC addresses.
2. Click the Delete table button.
Configure Advanced Radio Settings
 To configure advanced radio settings:
1. Select Network Config > Wireless Settings > Radio Settings. The Radio Settings
screen displays (see Figure 322 on page 546).
2. Click the Advanced option arrow in the upper right of the Radio Settings screen. The
Advanced Wireless screen displays:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR UTM5 and is the answer not in the manual?

NETGEAR UTM5 Specifications

General IconGeneral
BrandNETGEAR
ModelUTM5
CategoryFirewall
LanguageEnglish

Related product manuals