Firewall Protection
155
ProSecure Unified Threat Management (UTM) Appliance
Figure 85.
2. In the Add Customer Service section of the screen, enter the settings as explained in the
following table:
3. Click Apply to save your settings. The new custom service is added to the Custom Services
table.
Table 32. Services screen settings
Setting Description
Name A descriptive name of the service for identification and management purposes.
Type From the Type drop-down list, select the Layer 3 protocol that the service uses as its
transport protocol:
•TCP
• UDP
•ICMP
ICMP Type A numeric value that can range between 0 and 40. For a list of ICMP types, see
http://www.iana.org/assignments/icmp-parameters.
Note: This field is enabled only when you select ICMP from the Type drop-down list.
Start Port The first TCP or UDP port of a range that the service uses.
Note: This field is enabled only when you select TCP or UDP from the Type drop-down list.
End Port The last TCP or UDP port of a range that the service uses. If the service uses only a single
port number, enter the same number in the Start Port and End Port fields.
Note: This field is enabled only when you select TCP or UDP from the Type drop-down list.
To Next Page
Loading...
Need help?
General