Virtual Private Networking Using IPSec Connections
304
ProSecure Unified Threat Management (UTM) Appliance
4. Specify the settings that are explained in the following table.
5. Click Apply to use the new settings immediately, and click Save to keep the settings for
future use.
6. Click the Advanced tab in the Authentication pane. The Advanced pane displays.
Figure 182.
Table 74. VPN client authentication settings (Mode Config)
Setting Description
Interface Select Any from the drop-down list.
Remote Gateway Enter the remote IP address or DNS name of the UTM. For example, enter
10.34.116.22.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the UTM. For example, enter H8!spsf3#JYK2!. Confirm the key in the
Confirm field.
IKE Encryption Select the 3DES encryption algorithm from the drop-down list.
Authentication Select the SHA1 authentication algorithm from the drop-down list.
Key Group Select the DH2 (1024) key group from the drop-down list.
Note: On the UTM, this key group is referred to as Diffie-Hellman
Group 2 (1024 bit).
To Next Page
Loading...
