Monitoring System Access and Performance
507
ProSecure Unified Threat Management (UTM) Appliance
Reboot and Shut Down the UTM
You can perform a remote reboot (restart), for example, when the UTM seems to have
become unstable or is not operating normally.
Note: Rebooting breaks any existing connections either to the UTM (such
as your management session) or through the UTM (for example,
LAN users accessing the Internet). However, when the reboot
process is complete, connections to the Internet are automatically
reestablished when possible.
To reboot the UTM, locate the Reboot the System section on the Diagnostics screen. Click
the Reboot button. The UTM reboots. (If you can see the unit: The reboot process is
complete when the Test LED on the front panel goes off.)
Note: See also Reboot without Changing the Firmware on page 426.
To shut down the UTM, locate the Reboot the System section on the Diagnostics screen.
Click the Shutdown button. The UTM shuts down.
You can shut down the UTM using the web management interface,
but you cannot start up the UTM using the web management
interface.
To Next Page
Loading...
Need help?
General