xDSL Module for the UTM9S
542
ProSecure Unified Threat Management (UTM) Appliance
Note: You can also configure the failure detection method for the
auto-rollover mode on the Advanced screen. This procedure is
discussed in Configure the Failure Detection Method on page 532.
To configure advanced WAN options:
1. Select Network Config > WAN Settings.
2. Click the Edit button in the Action column of the SLOT-x entry. The SLOT-x ISP Settings
screen displays (see Figure 307 on page 522, which shows the SLOT-2 ISP Settings screen
as an example).
3. Click the Advanced option arrow in the upper right of the screen. The SLOT-x Advanced
Options screen displays. (The following figure shows the SLOT-2 Advanced Options screen
as an example.)
Figure 321.
4. Enter the settings as explained in the following table:
Table 142. Advanced DSL settings
Setting Description
MTU Size
Make one of the following selections:
Default Select the Default radio button for the normal maximum transmit unit (MTU)
value. For most Ethernet networks this value is 1500 bytes, or 1492 bytes for
PPPoE connections.
To Next Page
Loading...
