Getting Started FLUOVIEW/Online Help
IV.
OPERATION INSTRUCTIONS
IV.
1-63
Page
2. Click the <SU Control> button at the bottom of the panel. The window as shown
below will appear.
Fig. 1-12 [Optical System Configuration] Window
Virtual channels can be used. For the virtual channels, see section 2-2-8-1,
“Virtual Channel”.
3. The filter of the showed kind type is set up in the scan unit.
The [Microscope Configuration] window is designed to give guidance
on the system configuration. The red blinking light does not stop even
after the indicated configuration point has been changed.
4. Click the <Close> button to click the window.
[Laser Unit] group box
Shows the type of laser to be used.
(With the laser combiner operation, the laser type
is set and displayed automatically.)
When the <On> button is pressed-in, the laser is
oscillating the beam.
When not using laser for a long time, in order to
suppress useless electric-power consumption, we
recommend you making <Stby> mode.
When the <Stby> button is pressed-in, the laser is
not oscillating.
When the [Auto standby] check box is checked,
the [After] text box appears below it.
The laser oscillation stops when the time shown in
this box has elapsed after the end of laser
scanning. The laser is suspended as standby
mode (using Ar or Kr-laser) or the laser oscillation
stops (using UV-Ar laser)
When the time shown in this box has elapsed after
the end of laser scanning.
[TD Unit] group box
Shows the transmitted light detection.
[Dyes]
Shows the dyeing method set for
each channel.
[Manual Scan Unit] group box
Shows the type of filters suitable
for the dyeing method.
NOTE
TIP
To Next Page
Loading...
