Appendix I List of Functions in the [Active Overlays] Dialog Box/Coordinate Position Data
IV.
OPERATION INSTRUCTIONS
IV .
I-2
Page
Appendix I-1-2 Y-Coordinate
The Y-coordinate position with respect to the top left corner of the screen is displayed.
«Syntax»
<y[ [hotspot] [raw/calibrated] value [units]]>
Arguments inside [ ] can be omitted.
If [raw/calibrated] is omitted, the same setting as when [calibrated] is specified will be
applied.
«Setup Procedure»
1. Enter “y” as the first character inside < >.
2. Add the following characters to set the display method.
hotspot : Display measurement points with “+” markings.
raw : Display data in pixel values.
calibrated : Display data in numerical values (µm).
units : Display the unit (pixels/µm).
«Examples»
<Input character strings> <Displayed strings (** represent figures.)>
<y raw value> …………………………………**
<y hotspot raw value>………………………..+**
<y hotspot calibrated value units>………….+**µm
<x hotspot raw value>,<y raw value> ……..+(**,**)
The detailed display procedure is described in section 2-11-3, “Viewing the
X- or Y-Coordinate Position of Image” in Volume [OPERATION].
TIP
To Next Page
Loading...
