Olympus FLUOVIEW FV300 - Examples of Operation Procedures

APPLIED OPERATIONS/General Operation Procedure
IV. OPERATION INSTRUCTIONS
IV . 2-5
Page
2-1-3 Examples of Operation Procedures
Begin using the FLUOVIEW system by acquiring an image or opening an image in a file.
The procedures for the subsequent operations such as image processing are not in
question here. For the detailed operation method of each item in the procedure, see the
section specified in parentheses (( )).
Example 1) To perform XYZ observation of a cell,
apply filter processing to the image,
display animation to identify the cell
shape, then calculate the area, and
save the obtained image data:
Example 2) To open a previously acquired image in
a file, measure the intensity distribution
and edit data with Excel:
Specify the area to be measured
Measure the intensity distribution.
(Section 2-7-2)
Exit from the FLUOVIEW software
and turn power OFF.
(Sections 1-2-14 & 1-2-15)
Save the measurement data in the
Excel format.
(Section 2-11-1)
Turn power ON and start the
FLUOVIEW software.
(Sections 1-2-1 & 1-2-2)
Open an image in a file.
(Section 2-3-2)
Acquire an image.
(Section 2-2)
Turn power ON and start the
FLUOVIEW software.
(Sections 1-2-1 & 1-2-2)
Apply filter processing.
(Section 2-6-1)
Display the animation.
(Section 2-9-2)
Measure area
(Section 2-7-3-2)
Exit from the FLUOVIEW software
and turn power OFF.
(Sections 1-2-14 & 1-2-15)
Save the image.
(Section 2-3-1)
When
there is
another
area to be
measured
Read the saved measurement data
with Excel and edit it.