Olympus FLUOVIEW FV300 - Animation; Changing the Successive Image Display Position

APPLIED OPERATIONS/Viewing 3D Image
IV. OPERATION INSTRUCTIONS
IV . 2-304
Page
4. Select the option button of the speed to be varied.
5. Set the desired display speed in the scale on the right.
6. Click the <OK> button to close the [Animation speed] dialog box.
2-9-1-2 Changing the successive image display position
The successive display position of multiple image slices in an image can be changed
using a bottom displayed at the top of the [display] panel.
1. Display the [display] panel of the image subjected to successive display position
change at the front.
2. Click the mouse right button on the <Display> button at the top of the [Display]
panel to display a scale. (The following figure shows the scale with an XYZT
image.)
3. Drag the scale to another position to move the successive display position to the
position.
Entering the value directly in the text box can also move the display position.
2-9-2 Animation
Images composed of multiple image slices acquired by varying the multiple sections
(XYZ observation, XYZT observation) can be built into animation image, which can be
displayed in 3D by rotating images.
1. Display the [Display] panel of the image composed of multiple image slices.
2. When the images were acquired in the multi-channel mode, select whether
animation is built from images of more than one channel or from an image of only
one channel.
To select the target channel(s), use the <Display channel switch> buttons. Only the
channel(s) being displayed will be used in the animation building.
Example) When only the Ch1 image is displayed, only the Ch1 image is used.
<Display> button
<Display channel switch>
buttons
Drag the scale or click a point
on it to change the display
position to a position before or
after the current position.
The display position can also
be changed by direct entry of
the value.