Olympus FLUOVIEW FV300 - Building a 3 D Image to be Viewed through Color (Red;Green) Eyeglasses2-293

APPLIED OPERATIONS/Viewing 3D Image
IV. OPERATION INSTRUCTIONS
IV . 2-309
Page
2-9-4 Building a 3D Image to be Viewed Through Color (Red/Green) Eyeglasses
Images composed of multiple image slices acquired by varying the multiple sections
(XYZ observation) can be built into an image which looks 3D when viewed through a pair
of color (red/green) eyeglasses. This image can be viewed three-dimensionally by
watching them with two eyes for a while.
The operation is similar with animation. Perform steps 1 to 10 in section 2-9-2,
“Animation”, then proceed to the following steps.
1. Check the [Stereo Pair] check box.
2. Click the <Begin Visualize> button to start building the images. When the building
completes, the built image is displayed in the [3D Animation] panel.
The status bar shows the progress of building processing.
During the building, the <Begin Visualize> button turns into the <Cancel
Visualize> button. Click the <Cancel Visualize> button if you want to cancel
the building.
3. The following buttons are displayed at the top of the [Display] panel.
These buttons can be used to switch the 3D images between the Ch1-only image,
Ch2-only image and Ch3-only image. Select the channel(s) of interest.
4. Watch the image through a pair of color (red/green) eyeglasses.
The color (red/green) eyeglasses can also be used to view the animation.
To start animation, click the <Successive display> button.
<Cancel Visualize>
button
TIP
TIP
3D image for color (red/green) eyeglasses.
TIP