Olympus FLUOVIEW FV300 - Setting the Highest Scan Speed

Getting Started FLUOVIEW/Outline of LSM Observation Procedures
IV. OPERATION INSTRUCTIONS
IV . 1-46
Page
1-2-12-4 Setting the Highest Scan Speed
1. Set the scan speed to the fastest speed by using the scale in the [Scan Speed] group
box in the [Acquire] panel
The focus mode makes it possible to increase the line skipped scan speed.
From the page tabs on the bottom right of the [Acquire] panel, select the
[Settings] sub-panel.
Select either option button in the [Focus Mode] group box.
The focus mode is enabled when acquiring images using the <Focus>
button.
The Focus function reduces the scanning time by line skipped scan.
As a result, the acquired images become coarse.
[Scan Speed] group box
Set the scan speed by clicking a point on
the scale line.
NOTE
TIP
[Focus Mode] group box
[X2] option button
A
cquires image at twice the
highest speed.
[X4] option button
A
cquires image at 4 times the
highest speed.
Increasing the number of
divided images in the [Display]
panel, line skipped scan at 4
times (Focus) cannot be done.