Olympus FLUOVIEW FV300 - Image Acquisition Procedure (Section (A))

APPLIED OPERATIONS/General Operation Procedure
IV. OPERATION INSTRUCTIONS
IV . 2-3
Page
2-1-1 Image Acquisition Procedure (Section (A))
This section describes the procedure for acquiring images. See sections 2-2 and after
for the actual operation methods. The detailed operation methods of each item in the
procedure are described in the section specified in parentheses (( )).
Go to “Process the image”.
After “Turn power ON and start the FLUOVIEW software”,...
XY observation
(Section 2-2-1)
XT observation
(Section 2-2-2-2)
XYZ observation
(Section 2-2-2-4)
XYT observation
(Section 2-2-2-5)
XYZT observation
(Section 2-2-2-6)
TIME
Acquire an image in an observation mode.
(FLUOVIEW provides the following observation modes.)
Configure the system and confirm the images to be observed.
The system configuration and image confirmation are described in details in section
1-2, “Outline of LSD Observation Procedures” in the [OPERATION] Volume. Refer
to this section as required.
TIME
(A)
(B)
TIME
XZ observation
(Section 2-2-2-1)
XZT observation
(Section 2-2-2-3)
TIME
When saving the
image in a file:
Save the acquired data in a file.
(
Section 2-3-1
)
With this system, the observation
by XY scanning is called simply as
“XY observation”.