APPLIED OPERATIONS/Changing the Image Display Method
IV.
OPERATION INSTRUCTIONS
IV .
2-199
Page
2-5 Changing the Image Display Method
The method of displaying an image acquired by observation or opened from a file can be
changed as described below.
2-5-1 Displaying an Image in Simulated Colors
1. Display the [Display] panel of the image to be colored at the front.
2. Click the <LUT> button in the toolbar at the bottom left of the screen. The [Color
Tool] dialog box appears.
Fig. 2-64 [Color Tool] Dialog Box
3. When the image was acquired from more than one channel, select the channels to
be colored using the [Ch1], [Ch2] and/or [Ch3] option buttons. (The [Ch1], [Ch2]
and [Ch3] option buttons are displayed only when an image acquired in the 2-
channel or 3-channel mode is displayed (selected).
4. From the [Standard Color LUTs] group box, select the desired color button. The
selected LUT will be applied immediately to the image in the [Display] panel.
5. Click the <OK> button.
The [Apply to all views] check box can be selected while the [Display] panel
showing multiple images created using the [Tile] panel is displayed.
When this check box is checked, all changes are applied to all of the
images shown in the [Display] panel.
<LUT> button
TIP
To Next Page
Loading...
