Getting Started FLUOVIEW/Online Help
IV.
OPERATION INSTRUCTIONS
IV
. 1-64
Page
1-3-2-4 Configuring the Microscope (Combination with BX51, BX61, IX81)
When the combination with BX51, BX61, or IX81 is in use, the microscope and scan unit
(FV500) can be configured on the FLUOVIEW software.
Use the following procedure to configure the microscope.
1. From the panel page tabs shown on the bottom right of the [Acquire] panel, select
the [Settings] sub-panel.
Fig. 1-13 [Settings] Sub-panel
<Scope Control> button
Sets the system.
To Next Page
Loading...
