APPLIED OPERATIONS/Changing the Image Display Method
IV.
OPERATION INSTRUCTIONS
IV .
2-212
Page
2-5-6 Switching the Display Method of Multiple Images
With images composed of multiple slices, such as time-lapse images or images
acquired by changing the cross-sections, the image to be displayed at the front position
can be switched or the images can be displayed successively.
1. Display the [Display] panel of the multiple images.
The buttons as shown below are displayed at the top of the [Display] panel.
2. To switch the image to the image of another cross-section, click the <Z/T series
switch> button then, from the displayed list of buttons, click the <XYZ series>
button.
To switch the image to the image of another moment in the elapsed time, click the
<Z/T series switch> button then, from the displayed list of buttons, click the <XYT
series> button. (The icon in the <Z/T series switch> button will change to the icon of
the selected button.)
3. Display the image to be displayed at the front by using the <Display> buttons at the
top of the [Display] panel.
xxx
<XYZ series> button
Displays one of multiple images by selecting
it according to the cross-section (Z).
<Set start position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
start. (“0” is set when this button is not used.)
<Display> button
Press to start display of n-slices of image from the start position to the end position sequentially
(successive display) or one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image
slices by advancing frame by frame.
<Display> button
Press to start display of n-slices of image from the end position to the start position sequentially
(successive display) or one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image slices by
advancin
frame b
frame.
<Bound> button
Every time successive display or frame-by-frame display in a
direction ends at the start or end position, the display is restarted in
the opposite direction.
<Set end position> button
When successive display or frame-by-frame display
is required, set the image with which the display
should end. (Assuming that the number of images is
n, “n-1” is set when this button is not used.)
<Z/T series switch> button
<XYT series> button
Displays one of multiple images by selecting
it according to the time (T).
<Loop> button
Successive display or frame-by-frame display is
repeated in the same direction.
<Loop/Bound switch> buttons
<Display speed switch> buttons
Set the speed of successive display.
<Rabbit> button
Press for successive display of image slices without pause.
<Clock> button
Press for successive display of image slices at the time interval set in the [Time series] sub-panel.
<Turtle> button
Press for successive display of image slices at an interval of 0.8 sec.
To Next Page
Loading...
