SYSTEM OVERVIEW/Features of FLUOVIEW FV300
III .
SYSTEM OVERVIEW
III .
1-2
Page
1-2 Features of FLUOVIEW FV300
1. The detector has 12-bit resolution and is capable of detecting very small changes
in fluorescence inside cells.
2. The system has high resolution of a maximum 2048 x 2048 pixels. The output video
signal is non-interlaced to provide a clear image without flickering.
3. The transmitted light is detected by a photomultiplier to offer a bright, sharp
transmitted image.
4. The auto gain adjustment feature eliminates the need for complicated gain
adjustment operation.
5. A total of 3 image channels, including up to 2 fluorescence images and a
transmitted image, can be acquired simultaneously.
6. The confocal aperture can be selected from 5 positions so the optimum confocal
aperture for each objective can be selected with one-touch operation.
7. High-speed scanning acquires 4 images per second (512 x 512 pixels).
8. Sequential scan for acquiring images without crosstalk.
9. In addition to raster scanning, scanning modes such as vector scanning and
oblique scanning are provided to meet a wide range of applications.
10. When using the system with AOTF (FV5-COMBA), the following functions are
available.
x Line Kalman scanning
x Line sequential scanning
x Image acquisition in the REX/Bleach mode(FRAP experiment)
11. One of the two DMs can be selected using the excitation DM selector knob.
12. The ports for introducing the fiber are provided on two positions, that is, on the rear
and left side panels of the scan unit. (The port on the left side panel accepts only
the cable for laser wavelengths of 430 nm or less.)
To Next Page
Loading...
