Olympus FLUOVIEW FV300 - Checking the Image Information;Acquisition Parameters

APPLIED OPERATIONS/Saving, Opening and Shredding Images
IV. OPERATION INSTRUCTIONS
IV . 2-137
Page
2-3-5 Checking the Image Information/Acquisition Parameters
1. Click the <Experiment List> button in the toolbar at the bottom of the [File I/O] panel.
The [Experiments in Memory] dialog box appears as shown below.
Fig. 2-36 [Experiments in Memory] Dialog Box
2. In the [Experiments in Memory] dialog box, select the file name of the image to
check the image information and acquisition parameters and click the <Comments>
button.
3. Display the [Image Attributes] panel at the front. The panel as shown below
appears, where the information on the selected image is shown.
Fig. 2-37 [Image Attributes] Panel
<Experiment List> button
[Intensity]
Shows the length of the data
expressing the intensity value.
[CH]
Shows the number of image
acquisition channels.
[Z]
Dis
p
la
y
s number of Z slices.
[Z]
Shows the number of
steps in the Z-direction.
[Lens Magnification]
Displays objective Lens
Magnification when the image
is acquired.
[X Resolution]/[Y Resolution]
Show the lengths per pixel in
the X- and Y-directions.
[X]/[Y]
Show the resolution values
in the X- and Y-directions.