Olympus FLUOVIEW FV300 - Appendix F User Registration; Appendix G USER REGISTRATION of FV300

Appendix G USER REGISTRATION OF FV300/
IV. OPERATION INSTRUCTIONS
IV . G-1
Page
Appendix G USER REGISTRATION
OF FV300
FLUOVIEW FV300 can store the system setup information (PMT Voltage, Gain, Offset, etc.) on a per-user
basis.
To make this possible, you have to register yourself as a user and log in personally when starting up the FV300
software.
Appendix G-1 User Registration
Register yourself as a new user.
1. Double-click the [FLUOVIEW Setup] icon on the desktop.
Then the dialog box as shown below appears.
2. Click the [Users] icon in [Hardware Settings] to display the [FLUOVIEW Users]
panel in the front position.
[FLUOVIEW Setup] icon
<Add a user and Log in> button
Used to add a new user.
<Reset user to Factory Defaults> button
Resets the system setups of the users
selected in the list box to the factory defaults.
<Delete a user> button
Deletes the user selected in the list box.
(The Administrator and the user who log
in now cannot be deleted.)
[Users] icon