Olympus FLUOVIEW FV300 - Successive Display of Images

APPLIED OPERATIONS/Viewing 3D Image
IV. OPERATION INSTRUCTIONS
IV . 2-302
Page
2-9-1 Successive Display of Images
Images composed of multiple image slices acquired by varying the multiple sections
(XYZ observation, XYZT observation) can be displayed successively using the buttons
at the top of the [Display] panel as shown below.
1. Display the [Display] panel of the image composed of multiple image slices.
2. The buttons as shown below are displayed at the top of the [Display] panel. If the
<XYZ series> button is not displayed under the <Z/T series switch> button while
the images were acquired in XYZT observation mode, click the <Z/T series switch>
button and click the <XYZ series> button in the displayed list of buttons.
3. Display the image slice to start the successive display by using the <Display>
button at the top of the [Display] panel.
xxx
<XYZ series> button
Displays one of multiple images by selecting
it according to the cross-section (Z).
<Set start position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
start. (“0” is set when this button is not used.)
<Display> button
Press to start display of n-slices of image from the start position to the end position sequentially
(successive display) or one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image
slices by advancing frame by frame.
<Display> button
Press to start display of n-slices of image from the end position to the start position sequentially
(successive display) or one (frame-by-frame display) or to stop successive display.
Holding the button displays image slices in successive display and clicking it displays image slices by
advancin
g
frame b
y
frame.
<Bound> button
Every time successive display or frame-by-frame display in a direction
ends at the start or end position, the display is restarted in the opposite
direction.
<Set end position> button
When successive display or frame-by-frame display is
required, set the image with which the display should
end. (Assuming that the number of images is n, “n-1” is
set when this button is not used.)
<Z/T series switch> button
<XYT series> button
Displays one of multiple images by selecting
it according to the time (T).
<Loop> button
Successive display or frame-by-frame display
is repeated in the same direction.
<Loop/Bound switch> buttons
<Display speed switch> buttons
Set the speed of successive display.
<Rabbit> button
Press for successive display of image slices without pause.
<Clock> button
Press for successive display of image slices at the time interval set in the [Time series] sub-panel.
<Turtle> button
Press for successive display of image slices at an interval of 0.8 sec.