APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-73
Page
2-2-7 High-Speed Image Ac quisition
An image can be acquired in 0.25 second.
This image acquisition mode is valid under the following condition:
x Max. 2 channels
x Image size: 512 x 512 pixels
x Zoom ratio of 2X or more, with setting in 2X steps
1. Check one or both of the [Ch] check boxes in the [Ch] group box in the [Acquire]
panel.
2. Select the [Surface XY-Norm] option button in the [Mode] group box in the
[Acquire] panel and select <Fast> from the list displayed below it.
[512 by 512] is set automatically in the [Size] drop-down list in the [Mode] group
box.
“X2” is set and shown in gray-out display automatically in the [Zoom] scale in the
[Pan] group box.
3. To change the zoom ratio, use the [Zoom] scale in the [Pan] group box.
4. Click an image acquisition button such as the <XY Repeat> button.
High-speed image acquisition is possible only in XY, XYT and XT
observations.
5. After image acquisition, select <Normal> under the [Surface XY] option button in
the [Mode] group box in the [Acquire] panel to return from the image acquisition
mode.
TIP
<XY Repeat> button
To Next Page
Loading...
