Olympus FLUOVIEW FV300 - Intensity Values on a Planar Region (Birds Eye View)

APPLIED OPERATIONS/Image Analysis
IV. OPERATION INSTRUCTIONS
IV . 2-277
Page
2-7-1-2 Intensity Values on a Planar Region (Bird’s Eye View)
The intensity values on a region in an image can be displayed graphically.
1. Display the [Single] sub-panel at the front.
2. Display the [Display] panel of the image to be subjected to the intensity checking at
the front.
3. When the image was acquired in the multi-channel mode, select whether the multiple
channels are analyzed simultaneously or only one channel is analyzed.
To select the target channel(s), use the <Display channel switch> buttons. Only the
channel(s) being displayed will be analyzed.
Example) When only the Ch1 image is displayed, only the Ch1 image is analyzed.
For the switching of channels, see section 2-5-3, “Switching the Display
Channels”.
4. Click the <Annotate> button in the toolbar at the bottom of the [Analyze] panel. A list of
buttons appear as shown below.
5. From the displayed buttons, click the <Rectangular> button, <Circle> button or
<Polyregion> button.
<Display channel
switch> button
<Annotate> button
TIP