APPLIED OPERATIONS/Saving, Opening and Shredding Images
IV.
OPERATION INSTRUCTIONS
IV .
2-122
Page
2-3-1-4 Saving Animation images
Transform a created animation image into the AVI file format and save it in the file type
which can display the animation image without this software.
1. Create an animation image.
Refer to “2-9-2 Animation” for details.
2. Display the [Display] panel of the created animation image at the front.
The AVI file is created to save the animation at the display speed mode
selected here. For varying the animation display speed, see section 2-9-1-
1, “Changing the Successive Display Speed”.
One Point !
When saving image slices acquired in Z observation, it is recommended to lower
the animation display mode by clicking the <Turtle> button. (If image slices are
saved with the <Rabbit> button selected, the display speed of the animation
speed would become too high.)
To change the animation image display speed, see section 2-9-1-1, “Changing the
successive display speed”.
3. Select whether saving images from multiple channels simultaneously or only an
image from a channel if the images to be saved are acquired from multiple
channels.
Use the <Display channel switch> buttons for this selection. The image is saved
according to the condition of the selected channel.
For the channel switching, see section 2-5-3, “Switching the Displayed
Channels”.
TIP
TIP
To Next Page
Loading...
