Appendix I List of Functions in the [Active Overlays] Dialog Box/Intensity Data
IV.
OPERATION INSTRUCTIONS
IV .
I-4
Page
Appendix I-2 Intensity Data
The intensity value can be displayed.
When images are overlapped, the intensity value of each image is accompanied with the
channel number placed after it.
«Syntax»
<intensity[ [hotspot] [raw/calibrated] value [units]]>
Arguments inside [ ] can be omitted.
If [raw/calibrated] is omitted, the same setting as when [calibrated] is specified will be
applied.
«Setup Procedure»
1. Enter “intensity” as the first character inside < >.
2. Add the following characters to set the display method.
hotspot : Display measurement points with “+” markings.
raw : Display data in values between 0 and 4095.
calibrated : Display data in numerical values (µm).
units : Display the unit if this has been set.
(Same as the concentration computation in FV-TIEMPO)
«Examples»
<Input character strings> <Displayed strings (** represent figures.)>
<intensity raw value> ..................................**
<intensity hotspot raw value> ......................***(1),**(2)
(When images are overlapped)
The detailed display procedure is described in section 2-11-2, “Viewing the
Intensity Value of Image” in Volume [OPERATION].
TIP
To Next Page
Loading...
