APPLIED OPERATIONS/General Operation Procedure
IV.
OPERATION INSTRUCTIONS
IV .
2-4
Page
2-1-2 Image Acquisition Procedure in an Observation Mode (Section (B))
As an example of “Acquire an image in an observation mode”, this section describes the
procedure in the XY observation mode. For the procedures in other observation modes,
see section 2-2-2, “Image Acquisition in Other Observation Modes” as well as the
following procedure.
Set the acquisition parameters.
(Section 2-2-1-3)
z Observation mode
z Scanning speed
z Image brightness
Acquire an image in the XY observation mode.
(Section 2-2-1-4)
XY observation
(Section 2-2-1)
Perform accumulation.
(Section 2-2-1-5)
After “Configure the system and confirm the images
to be observed”...
Go to “Save the acquired data in a file.” or “Process the image”.
When noise is noticeable:
(B)
z Cross-section to be
observed
z Area to be observed
To Next Page
Loading...
