Olympus FLUOVIEW FV300 - Switching the Displayed Channels (Ch1, Ch2, Ch3)

APPLIED OPERATIONS/Changing the Image Display Method
IV. OPERATION INSTRUCTIONS
IV . 2-204
Page
To load a previously saved LUT, click <Load LUT>.
2-5-3 Switching the Displayed Channels (Ch1, Ch2, Ch3)
The buttons on the bottom left of the screen can be used to select where the image of a
single channel or images of multiple channels are to be displayed. For the simultaneous
display of multi-channel images, see section 2-5-4, “Displaying Images of Multiple
Channels Simultaneously”.
1. Display the [Display] panel of for the image obtained from multiple channels at the
front.
2. Click the image to display the <Display channel switch> buttons on the bottom left
of the image.
3. Click the <Channel 1>, <Channel 2> and/or <Channel 3> buttons of the <Display
channel switch> buttons.
The [Display] panel shows the images of the channels selected with the <Display
channel switch> buttons. At the same time, the clicked <Display channel switch>
buttons are displayed in the pressed-in condition.
4. Press the previously pressed <Display channel switch> buttons to let them
disappear.
Fig. 2-67 Panel Displaying the Channel 2 Image
<Display channel switch>
buttons
<Channel 1> button
<Channel 2> button
<Channel 3> button
TIP