Olympus FLUOVIEW FV300 - Displaying the X-Coordinate;Y-Coordinate of the Image

APPLIED OPERATIONS/Entering Comment in Image
IV. OPERATION INSTRUCTIONS
IV . 2-321
Page
2-12-3 Displaying the X-coordinate/Y-coordinate of the Image
The X-coordinate position or the Y-coordinate position of any pixel of an image can be
displayed.
1. Display the [Display] panel of the image that you want to display the X-coordinate
position or the Y-coordinate position at the front.
2. In the list of buttons displayed, click the <Text> button. The dialog box as shown
below appears.
Fig 2-144 [Active Overlays] Dialog Box
3. In the drop-down list inside the dialog box, select “x = <x hotspot value “” units> “ to
display the X-coordinate position or “y = hotspot value “” units>“ to display the Y-
coordinate position.
4. On the image, place the mouse pointer on the position that you want to display the
X-coordinate position or the Y-coordinate position and click the mouse.
5. Click the <Close> button to close the [Active Overlays] dialog box.
The displayed value indicates the distance from the origin when assuming
the upper left of the image as the origin.
<Text> button
TIP