Olympus FLUOVIEW FV300 - Software Setup; Re-Setup or Updating of the Software

Software Setup/Re-setup or Updating of the Software
V . MAINTENANCE
V. 1-1
Page
1 Software Setup
The FLUOVIEW software has been set up before it is delivered to the user.
A CD-ROM containing the software program is provided with FLUOVIEW. This CD-ROM is intended for use
when re-setup is required due to a fault or when the user wants to set up the software newly.
When the FLUOVIEW software is updated, the user is also requested to update the software in use accordingly.
For re-setup or updating of the software, see section 1-1, “Re-Setup or Updating of the Software” below and
follow the procedures given in it.
When you want to set up the software newly, see section 1-2, “New Setup of the Software” below and follow the
procedures given in it.
To set up the FLUOVIEW software, it is necessary that the computer in use
already has Microsoft Windows NT Version 4.0 (English version) or
Microsoft Windows 2000 (English version) installed in its hard disk.
A vacant space of 100 MB is required for the setup.
1-1 Re-setup or Updating of the Software
1. Insert the FLUOVIEW setup CD-ROM in the CD-ROM drive.
Then the dialog box as shown below appears.
If the dialog box doesn’t appear, run the 'Install.exe' file that is present in
the root directory of the CD-ROM.
2. Click the option button of the version of FV software installed, and click the <Start
Update> button.
3. [Update FV Software] dialog box is displayed and starts the current settings.
For save, carry out according to a wizard.
TIP
[Update from Ver.3.x] option button
When updating from FV software after
ver3.0, select this option button.
[Update from Ver.2.x] option button
When updating from FV software of
ver2. x, press this option button.
TIP