Olympus FLUOVIEW FV300 - New Setup of the Software

Software Setup/New Setup of the Software
V . MAINTENANCE
V. 1-3
Page
1-2 New Setup of the Software
The following procedure allows you to set up the FLUOVIEW software in a computer you
use.
1. Load the FLUOVIEW setup CD-ROM in the CD-ROM drive.
The dialog box as shown below will appear.
If the dialog box doesn’t appear, run the 'Install.exe' file that is present in
the root directory of the CD-ROM.
2. Select the <Open Readme> button.
3. When Readme.txt is displayed, read it carefully. Click the <Close> button on the
top left of the window to close Readme.txt.
The dialog box as shown below will appear.
4. Select the <Start Setup> button.
㪓㪚㫃㫆㫊㪼㪕㩷㪹㫌㫋㫋㫆㫅
TIP