Olympus FLUOVIEW FV300 - Executing the Protocol

APPLIED OPERATIONS/ Protocol processor
IV. OPERATION INSTRUCTIONS
IV . 2-170
Page
2-4-4 Executing the Protocol
The created protocol can be executed to acquire time series images.
1. In the [PAPP] window, click the <Start> button.
The number of rows in the [No.] list in the [PAPP] window becomes 2, and the
window display is reduced. The row being executed is show in reverse display and
the reverse-displayed row changes in synchronism with the change in the executed
track.
One Point!
The [PAPP] dialog box can be arranged as follows;
x Always display the [PAPP] dialog box at the front.
Check “On Top” in the [View] menu in the [PAPP] dialog box.
x Display the [PAPP] dialog box in full screen.
Check “Full Screen” in the [View] menu in the [PAPP] dialog box.
x Shrink the [PAPP] dialog box to the bottom of the screen while executing a
protocol.
Before executing a protocol, check the “To Bottom on Running” in the [View] menu in
the [PAPP] dialog box.
x Shrink the [PAPP] dialog box at any position in the screen while executing a
protocol.
Before executing a protocol, check “Shrink on Running” in the [View] menu in the
[PAPP] dialog box and move the [PAPP] dialog box to anywhere in the screen.
x [PAPP] window and [Display] panel are separated and displayed.
Prior to executing protocol, select “Share the screen with FV” from [View] menu of
[PAPP] window and make it checked state. When it is done so, “To Bottom on
Running” and “Shrink on Running” are simultaneously checked. Further, when check
of either “To Bottom on Running” or “Shrink on Running” is removed, the check of
“Share the screen with FV” is also removed.
2. When stopping the protocol, click the <Break> button.
When the protocol is executed again, click the <Start> button.
When clicked while the protocol is executed, the <Break> button performs
the same function as the <Stop Scan> button in the [Acquire] panel.
<Start> button
TIP