APPLIED OPERATIONS/Protocol processor
IV.
OPERATION INSTRUCTIONS
IV .
2-171
Page
3. To stop the protocol without executing it till the end, click the <End> button.
When clicked while the protocol is executed, the <End> button
performs the same function as the <Series Done> button in the
[Acquire] panel.
One Point!
The protocol can be processed using the items under the [Run] menu in the [PAPP]
window.
x Start executing the protocol.
Select “Start” in the [Run] menu in the [PAPP] window.
x Suspend executing the protocol.
Select “Break” in the [Run] menu in the [PAPP] window.
x Fast forward the protocol.
Select “Skip” in the [Run] menu in the [PAPP] window.
x Stop executing the protocol.
Select “End” in the [Run] menu in the [PAPP] window.
One Point!
䃁When [Stop when error occurs] is selected – checked from [Open] menu, process is
stopped in case that error occurs during protocol processing at the track where the
error occurred. In case that the check is removed, the process goes to next track
when error occurred.
䃁When [Stop an interval remaining timer during pause] is selected – checked from
[Option] menu, the time at pause is not counted. In case that the check is removed,
the time at pause is counted and, if the time counted exceeds the time set for track,
the process will be immediately started at next track when protocol is executed again.
<Break> button
<End> button
TIP
To Next Page
Loading...
