Olympus FLUOVIEW FV300 - Displaying Images of Multiple Channels Simultaneously; Displaying Images Separately Per Channel; Over and under Views. Single View); Views)

APPLIED OPERATIONS/Changing the Image Display Method
IV. OPERATION INSTRUCTIONS
IV . 2-205
Page
2-5-4 Displaying Images of Multiple Channels Simultaneously (Side By Side VIews,
Over And Under Views. Single View)
Images from multiple channels can be displayed either by merging them or placing them
side by side. It is also possible to display the image of only one of these channels.
Use the buttons displayed at the top of the [Display] panel and those on the bottom right
which are displayed when the corresponding image is clicked. For the display of the
image of only one channel, see section 2-5-3, “Switching the Displayed Channels”.
2-5-4-1 Displaying Images Separately Per Channel (Side By Side Views, Over And Under
Views)
1. Display the [Display] panel of one of the images to be displayed side by side at the
front.
2. Click the <Display switching> button at the top of the [Display] panel. The list of
buttons as shown below appears.
<Display switching> button