Olympus FLUOVIEW FV300 - Building an Image from a Different Viewpoint; Building Extended Focus Image from XYZ Image; Display Switching to Built Image

APPLIED OPERATIONS/Building an Image from a Different Viewpoint
IV. OPERATION INSTRUCTIONS
IV . 2-293
Page
2-8 Building an Image from a Different Viewpoint
2-8-1 Building Extended Focus Image from XYZ Image
2-8-1-1 Display Switching to Built Image
An extended focus image can be built from XYZ (multiple sections) images and the
display can be switched to show the built image.
1. Display the [Display] panel of the XYZ (multiple sections) image.
2. The following button is displayed at the top of the [Display] panel.
(Usually, only the <XYZ series> button is displayed. When it is clicked, a list of
buttons appears as shown below.)
3. Click the <Extend> button.
4. Click the <Display> button at the top of the [Display panel] repeatedly to build the
extended-focus image.
(The extended-focus image can also be displayed by using the <Display> button to
start successive display.)
<Display>button
<Extend> button
Displays the extend image.
<XYZ series> button
Displays only one of multiple sections image slices.