APPLIED OPERATIONS/General Operation Procedure
IV.
OPERATION INSTRUCTIONS
IV .
2-2
Page
Acquire an image.
(According to the selected
observation mode)
For detailed operation procedures for image
acquisition, see section 2-1-1, “Image
Acquisition Procedure (Section A)”.
Open an image in a file.
(Section 2-3-2)
Turn power ON and start the FLUOVIEW software.
(Sections 1-2-1 & 1-2-2)
Process the image.
Observe the image.
x Observation of image shape
Image display in simulated colors
(Section 2-5-1)
LUT change (Section 2-5-2)
Simultaneous display of multi-channel
images (Section 2-5-4)
Side-by-side image display (Section 2-5-7)
Magnified/reduced image display
(Section 2-5-9)
Stereo 3D image display (Section 2-9-3)
Color-eyeglass 3D image display
(Section 2-9-4)
Animation display (Section 2-9-2)
Continuous display (Frame-by-frame
display) (Section 2-9-1)
x Observation of image change
over time
Side-by-side image display
(Section 2-10-1)
Continuous display (Frame-by-frame
display) (Section 2-10-2)
Measure the image.
x Measurement of image shape
Length measurement(Section 2-7-3-1)
Area measurement (Section 2-7-3-2)
x Measurement of image intensity
value and distribution
Intensity on a line (Line profile)
(Section 2-7-1-1)
Intensity on a plane (Bird’s eye view)
(Section 2-7-1-2)
Intensity distribution (Section 2-7-2)
Compile the presentation data.
Drawing characters on image (Section 2-12-1)
Drawing pictures on image (Section 2-12-2)
Drawing scales on image (Section 2-12-3)
Output the image at the printer.
(Section 2-13)
Exit from the FLUOVIEW software and turn power OFF.
(Sections 1-2-14 & 1-2-15)
Save the image.
(Section 2-3-1)
Filtering (Section 2-6-1) Contrast conversion (Section 2-6-2)
Inter-image operation (Section 2-6-3)
(A)
To Next Page
Loading...
