Olympus FLUOVIEW FV300 - Page 113

Getting Started FLUOVIEW/Online Help
IV. OPERATION INSTRUCTIONS
IV. 1-75
Page
㪏㪅 Set the parfocality correction values of objectives by repeating steps 6 and 7 for
each.
The [Pfcl Setup Wizard] group box displays the option button menu shown below.
Click the <Pfcl> button to activate the parfocality correction.
㪐㪅 Set the jog sensitivity values of the objectives.
Select the jog sensitivity of each objective from the [Jog Fine] drop-down list.
The drop-down list appears when clicking each value in the [Jog Fine].
㪈㪇㪅 After completing the settings, click the <Exit> button to close the dialog box.
When a dialog box is displayed to ask where or not you want to save the settings,
click <Yes> to save them, <No> to not to save them or the <Cancel> button to
return to the parfocality correction and jog sensitivity value setting.
[Jog Fine] group box
Select the jog sensitivity o
f
each objective from the
drop-down list.
The * mark represents the
value recommended.
Click to save the currently set
parfocality correction values and
close the dialog box.