Olympus FLUOVIEW FV300 - Page 124

APPLIED OPERATIONS/Image Acquisition
IV. OPERATION INSTRUCTIONS
IV . 2-10
Page
2. Setting the dyeing method
1) From the page tabs on the bottom right of the [Acquire] panel, select the [Dyes]
sub-panel.
Fig. 2-2 [Dyes] Sub-panel
2) Select the specimen dyeing method by dragging desired dye names in the
[Available Dyes] list box in the [Selected Dyes] group box to the field
immediately above the list box.
Fig. 2-3 [Dyes] Sub-panel
3) Click the <Apply> button to apply the selected dyeing method to the
[Channel1]/[Channel 2] group box on the upper part of the [Acquire] panel.
[Available Dyes] list box
Lists the available dyes. Select the
desired items from this list and
drag them to the field above it to
select the dyeing method.
<Clear> button
Clear the set dyeing method.
<Prev.> button
Sets the dyeing method which
was set last time by clicking the
<Apply> button.
<Apply> button
A
pplies the dyeing method
dragged in the [Selected
Dyes] group box to the
[Channel 1]/[Channel 2]
group box in the [Acquire]
p
anel.
Place the pointer on the
icon displayed in the
[Selected Dyes], and the
dyeing method is shown in
the pop-up display.
[Assign dyes manually] check box
Checking this enables the manual
setting. Dragging the dyeing method in
the list directly to the [Ch] group box
assigns the dye to the desired channel.