Olympus FLUOVIEW FV300 - Page 132

APPLIED OPERATIONS/Image Acquisition
IV. OPERATION INSTRUCTIONS
IV . 2-18
Page
8 Setting the Area to be Observed
When the observation targets are concentrated in a narrow area or when it is necessary
to observe the detail of a specific area, the image of a limited area can be acquired
selectively.
Fig. 2-8 [Pan] / [Zoom] Group Box
For instance, let us assume that the observation target is deviated at the top left of the
acquired image.
With this example, the area containing the observation target can be observed using the
following procedure.
1. Increase the zoom ratio using the [Zoom] scale in the [Acquire] panel.
2. The light-blue circle to the left of the [Zoom] scale represents the field visible
through the microscope, and the blue frame indicates the acquired image area.
Move the blue frame inside the circle using the <Pan> buttons so that the desired
observation targets are displayed in the [Live] panel.
The 4 buttons represent directions,
and clicking a button moves the
acquired image area in the direction
indicated by the button.
Clicking the square button on the
center returns the acquired image
area to the center.
Clicking a point in the scale area
allows the value to be changed
on a large scale.
Clicking the top or bottom arro
w
button allows fine adjustment o
f
the value.
Dragging the square knob allows
the value to vary directly.
Click a point inside the circle to change
the position of the acquired image area
Blue frame appears.