APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-38
Page
4 Setting the numbers of steps and acquired image slices
1. From the page tabs on the bottom right of the [Acquire] panel, select the [Z Stage]
sub-panel.
2. A number of steps is displayed in the [Step Size] text box. This number can be
changed using the <
> or <
> button in the [Step Size] text box.
The number of steps shown in the [Step Size] text box has been calculated
by the system so that the depth scale of the acquired image is identical to
the horizontal scale.
The number of steps calculated by the system may be erroneous
unless the XZT observation mode has been set previously.
The number of acquired images shown in the [Slices] text box can also be
input from the keyboard.
After setting [Start Z] (Z-direction scan start position) and [Stop Z] (Z-
direction scanning stop position), input the desired number of images in the
[Slices] text box. This automatically sets [Step Size] (number of steps).
TIP
NOTE
TIP
[Step Size] text box
[Slices] text box
To Next Page
Loading...
