APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-40
Page
7 Acquiring image
1. Click the <XZT> button in the [Acquire] panel.
The acquired image will be displayed in the [Live] panel.
While acquiring an image in the XZT observation mode, clicking the <STOP SCAN>
button changes the buttons at the upper part of the [Acquire] panel as shown below. The
<Resume> button restarts image acquisition at the frame next to the frame where the
acquisition is suspended.
8 Appending image
XZT image can be added after the image acquisition.
Immediately after acquisition of an image in the XZT observation mode, the buttons at
the upper part of the [Acquire] panel changes as shown below.
Click the <Append Next> button to append an image. An image will be acquired with the
same number of steps as the image acquired immediately before and appended to it.
Click the <Series Done> button when it is not required to append an image.
<Append Next> button
cquires another image and appends it
to the image acquired immediately
before.
<Series Done> button
Determines the acquired
images. Once this button is
clicked, it is not possible to
append an image.
<Resume> button
Restarts image acquisition at
the frame next to the frame
where the acquisition is
suspended.
<Series Done> button
Determines the acquired
images. Once this button is
clicked, it is not possible to
append an image.
To Next Page
Loading...
