Olympus FLUOVIEW FV300 - Page 171

APPLIED OPERATIONS/Image Acquisition
IV. OPERATION INSTRUCTIONS
IV . 2-57
Page
z Set the dyeing method
1. From the page tabs on the bottom right of the [Acquire] panel, select the [Dyes]
sub-panel.
Fig. 2-18 [Dyes] Sub-panel
2. Select the specimen dyeing method in the [Available Dyes] list box in the [Selected
Dyes] group box, and drag the selected method into the field immediately above
the list box.
3. Click the <Apply> button to apply the selected dyeing method to the
[Channel1]/[Channel 2] group box on the upper part of the [Acquire] panel.
When a dyeing method is selected from the [Available Dyes] list box and
the <Apply> button is clicked to apply it in the image acquisition channel,
the dyeing method emitting a shorter light wavelength than 570 nm is set to
Ch1 and that emitting a longer light wavelength is set to Ch2 automatically.
[Available Dyes] list box
Lists the available dyes. Select the
desired items from this list and drag
them to the field above it to select the
dyeing method.
<Clear> button
Clear the set dyeing method.
<Apply> button
A
pplies the dyeing method
dragged in the [Selected
Dyes] group box to the
[Channel 1]/[Channel 2]
group box in the [Acquire]
panel.
<Prev.> button
Sets the dyeing method which was
set last time by clicking the
<Apply> button.
Place the pointer on the
icon displayed in the
[Selected Dyes], and the
dyeing method is shown in
the pop-up display.
[Assign dyes manually] check box
Checking this enables the manual
setting. Dragging the dyeing method in
the list directly to the [Ch] group box
assigns the dye to the desired channel.
TIP