APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-59
Page
z Make the channel ready for image acquisition.
In the [Acquire] panel, make sure that the check box in the [Ch1] or [Ch2] group box
that shows the dyeing method is check-marked to indicate that the corresponding
channel is ready for image acquisition.
z Set the image brightness.
Adjust the brightness of the acquisition channel by using the [PMT], [Offset] and
[Gain] LED sliders in the [Acquire] panel. For details, refer to section 2-2-1-3-9,
“Adjusting the Image Brightness” in the [OPERATION] volume.
Ch2 check box
Ch1 check box
To Next Page
Loading...
