APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-64
Page
When dyeing methods are selected from the [Available Dyes] list box and
the <Apply> button is clicked to apply them in the image acquisition
channel, the dyeing methods emitting a shorter light wavelength than 570
nm are set to Ch1 and those emitting a longer light wavelength are set to
Ch2 automatically.
One Point!
The [Assign dyes manually] check box can also be used to set the dyeing method to the
desired channel.
1. Check the [Assign dyes manually] check box in the [Dyes] sub-panel.
2. Select the dyeing method in the [Available Dyes] list box and drag it directly to the
field of the [Ch] check box.
3. After dragging, the icon appears on the right of the [Ch] check box and the dyeing
method is set.
Dragging the icon to the out of the [Ch] check box field cancels the setting of the dyeing
method.
TIP
Icon
The dyeing method is set
[Assign dyes manually]
check box
To Next Page
Loading...
