APPLIED OPERATIONS/Image Acquisition
IV.
OPERATION INSTRUCTIONS
IV .
2-81
Page
Filters cannot be set if you are using the FV300. Please switch
manually.
Setting will disappear if <Normal> is selected at [Mode] group box of
[Acquire] panel after setting virtual channel. It is useful that the
setting is saved with use of <Save> button at [Acquisition Settings]
group box on [Settings] sub panel of [Acquire] panel before selecting
<Normal>.
When the laser to be used with a group has not been set, the [Laser Unit]
dialog box shows “No Laser has assigned yet”.
In this case, set the laser in the [Laser Unit] group box.
7. Adjust the image brightness for every group.
Select the group to adjust the image brightness in the [Group] drop-down list
displayed on the upper part of the [Acquire] panel.
Select a group before repeated scanning. The group selection cannot be
changed during repeated scanning.
8. Click the <XY Repeat> or <Focus> button to perform repeated scanning in order to
adjust the brightness of the channels.
Select a group before repeated scanning. The group selection cannot be
changed during repeated scanning.
9. Adjust the brightness using the [PMT], [Offset] and [Gain] LED sliders in the [Ch]
group box in the [Acquire] panel. For details, see section 2-2-1-3-9, “Adjusting the
image brightness”.
NOTE
[Group] drop-down list
Select the sequential scan
group.
TIP
<XY Repeat> button
<
>
TIP
TIP
NOTE
To Next Page
Loading...
