Olympus FLUOVIEW FV300 - Page 21

SYSTEM OVERVIEW/System Configuration
III . SYSTEM OVERVIEW
III . 1-9
Page
Input and output terminals on FV5-LCU back
Outputs for laser intensity
(Analog, 0-10V)
(VIS1 and VIS2 are for
invisible laser, UV is for UV
laser, IR is for IR laser and
Blanking is for switching laser
ON/OFF.)
(UV laser and IR laser are
optional.)
For connection to PC (PC-
SYSTEM), 50 pin.
For connection to FV5-
PSU (PC-SYSTEM), 50
pin.
For switching signals output
from the left connectors
(VIS1 and VIS2 are for invisible
laser, UV is for UV laser, IR is
for IR laser and Blanking is for
switching laser ON/OFF.)
(UV laser and IR laser are
optional.)
VIS1 VIS2 UV IR
VIS1VIS2 UV IR Blanking
Event output signal 1 (TLL)
Event output signal 0 (TLL)
Trigger input signal 1 (TTL)
Trigger input signal 0 (TTL)
Horizontal sync signal
(TTL)
Vertical sync signal (TTL)
For connection to FV5-TD
(Dsub 25 pin, male terminal)
For connection to FV5-PSU
(TD)
(Dsub 25 pin, male terminal)
For connection to (AOTF)
FV5-COMBA
(Coaxial connector)
Service connector