APPLIED OPERATIONS/Protocol processor
IV.
OPERATION INSTRUCTIONS
IV .
2-153
Page
Only available Laser type and PMT channel column is used with [Laser Intensity] and
[PMT Voltage].
The values in each cell are applied to the [Acquire] panel at the beginning of the
protocol.
When “Init” is specified in a cell, the value set in the [Init Val] box is applied.
The blank cell applies the value set to the track immediately above.
The width and height of PAPP window is adjustable. Width of each row is also
adjustable.
The columns are used to set the following data.
No.: Track number. The Track is available if it is checked.
Mode: Select the mode of the track.
New mode : Assign primary image acquisition mode. The scan mode listed
below can be assignable.
Series mode: This mode can set the previous scan mode to acquire
consecutive XYT, XYZT, or XZT image with the acquisition
parameter modified.
Sub-menu of New mode Description
Series
XY Acquires XY image.
X
XYT Acquires XYT image.
O
XYZ Acquires XYZ image.
X
XYZT Acquires XYZT image.
O
XT Acquires XT image.
X
XZ Acquires XZ image.
X
XZT Acquires XZT image.
O
Pt*T Acquires Point-T image.
X
O㩷㩷Series mode (track for linkage) can be connected continuously.
X㩷㩷Series mode (track for linkage) cannot be connected continuously.
When [Mode] column is changed and initializations for all subsequent
columns are required, put a check in [Refresh when changing Mode].
When information registered is not changed, uncheck [Refresh when
changing Mode] at [Option] menu.
Command : The MACRO command mode.
For : Start of repetition (repetition processing using variables)
Next : End of repetition (repetition processing using variables)
Start by: Select the image acquisition start method.
TIP
To Next Page
Loading...
