Olympus FLUOVIEW FV300 - Page 280

APPLIED OPERATIONS/ Protocol processor
IV. OPERATION INSTRUCTIONS
IV . 2-166
Page
x All of parameters that can be set for the Track can modify.
x Parameter that is deferent with the previous Track is colored with Red.
x Parameters that is modified on [Track] windows is colored with purple.
x When button is clicked, the setting of item checked at check box of
group box name is changed to the value in [Init Val] of [PAPP] window and [init] is
displayed.
x When button is clicked, the setting of item checked at check box of
group box name is acquired from FLUOVIEW software.
x When button is clicked, the setting of item checked at check box of
group box name is set to FLUOVIEW software.
x <Set Init Val> button loads [Init Val] box in [PAPP] window into
[Track] parameters.
One Point!
It is possible to select [Set Init Val] and [Get FV Status] from [Edit] menu.
When [Select All] is selected from [Edit] menu, checks will enter all check boxes of group
boxes.
When [Invert Selection] is selected from [Edit] menu, state of checks in all check boxes of
group boxes will be inverted. When check is entered, the check will be removed and,
when check is removed, the check is entered.
It is possible to select [Set to FV] from [Action] menu.
x <Get FV Status> button loads parameters which FLUOVIEW software
has.
x By pressing <Set> button, [Track] window setting is registered to
[PAPP] window.
x <Cancel> button is for close [Track] window.